4
STEP 6
Removing the Main Body
To remove the main body, push in the tab
as shown below using the key or flathead
screwdriver and slide main body up .
STEP 5
Attach Tray
Attach the tray to the wall cover plate as
shown in the figure on the (right). Push it
in until the tabs of the wall cover plate
fasten it.
STEP 3
Attach the main body and the
wall cover plate
Remove rubber dust plug from sensor
cable plug hole and discard. Align the
main body to the cover plate as shown
below and push into place until a clicking
sound is heard. Then, insert the sensor
cable plug to the main body.
STEP 4
Install the main body onto the
mounting plate
Align the main body to the installation
plate as shown in the figure below, and
then slide down to install the main body
onto the mounting plate.
Summary of Contents for SJS-1450
Page 2: ...2 Dimensions Parts ...
