Air Delights, Inc. • 9974 SW Arctic Dr. • Beaverton, Or. 97005
Phone: 800-440-5556 • Fax: 503-643-8224
www.airdelights.com
Copyright © 2009 SLOAN VALVE COMPANY
JSD6044.2
Printed 01/09
CARE AND CLEANING OF CHROME AND SPECIAL FINISHES
DO NOT use abrasive or chemical cleaners (including chlorine bleach) to clean
Soap Dispenser that may dull the luster and attack the chrome or special
decorative finishes. Use ONLY mild soap and water, then wipe dry with clean cloth
or towel.
While cleaning the bathroom tile, protect the Soap Dispenser from any splattering
of cleaner. Acids and cleaning fluids will discolor or remove chrome plating.
TROUBLESHOOTING GUIDE
1. Yellow LED light is flashing.
A. Soap level is low. Check level and change as needed.
B. Reset button was not pressed after the refill was installed. Press and release
reset button.
2. Red LED light is flashing (battery power only).
A. Batteries are low. Replace with four (4) new D-size alkaline batteries.
3. Soap does not dispense.
A. Check that power source is plugged in correctly.
B. Make sure batteries have been properly installed in the battery compartment.
C. Check soap path for clogging. Remove and replace as needed.
4. Soap does not dispense when user “waves” their hands under the
spout.
A. Hands must be held steady under the spout for soap to be dispensed.
5. Dispenser rotates due to users moving the spout.
A. Tighten the existing flange nut on the shank of the spout under the counter.
B. Add a second flange nut from Sloan to act as a jam nut in conjunction with the
nut already installed.
When assistance is required, please contact
Air Delights
Technical Support at:
800-440-5556
PARTS LIST
Item Part
Description
No.
No.
1
SJS-1-A
Spout Assembly
2A
Rubber Gasket
2B
Flange Nut
3
SJS-5
Motor Assembly
4
SJS-8
Pick-up Tube
5
SJS-1651
Soap Bottle
6
Mounting Screws (5)
7
SJS-4
Battery Compartment
8
D-size Alkaline Batteries (4) (supplied by others)
9
SJS-2
Repair Kit Tube Assembly Soap Path
10
SJS-3
Repair Kit Tube Assembly Extension
11
SJS-7
Optional AC Adapter (sold separately)
The information contained in this document is subject to change without notice.
1
2B
10
3
4
5
6
7
8 (BY OTHERS)
11
9
2A
Soap Path Replacement
A
In the event that the Soap Dispenser is not used for an extended period
and the Soap Path becomes clogged, slide the Soap Path out from the
Spout.
B
Clean or replace with a new
SJS-2 Soap Path.
O-RING
SOAP PATH
C
Slide the Soap Path into the
Spout.
