12
Two-Piece, Retractable Safety Blade Guard
When cutting head is lowered, the guard separates so material can
be cut.
Locking Switch: The “OFF” Position
Important:
We suggest that when the machine is not in use, the
switch be locked in the “OFF” position using a padlock (B) through
the holes in the switch trigger (A).
Work Piece Clamping
Clamp materials securely in vise so blade performance is not impeded. Angle bar should be
clamped in a position as shown:
The most efficient cuts are done if blade cuts the thinnest
section of material.
Recommended Cutting Capacity
WARNING:
Greater than recommended capacities may lead to tool and/or personal injury.
Note:
Cutting through any cross sectional area of material thicker than ½" tends to load up
the blade, and this will cause your tool to work harder.
Applicable Blade
Dimensions
14" (350mm) Outer Diameter x 1" (25.4mm) Hole Diameter
@
45º
@
90º
Work Pieces Configuration
(cross-section)
●
▄
●
▄
Maximum Cutting Capacity
4-⅛"
(105mm)
3-½"
×
3-½"
(90mm
x
90mm)
3-¼
"
x
3-¼"
(80mm
x
80mm)
5-⅛"
(130mm)
4-¾"
x
4-¾"
(120mm
x
120mm)
3-¾"
x
7"
(95mm
x
180mm)
Fig. 16
Fig. 17
Fig. 18
Fig. 19
Summary of Contents for 72905361120
Page 15: ...15 PARTS DIAGRAM...
Page 21: ...21...
