Slugger 72905361120, Instruction Manual

7

Motor Specifications and Electrical Requirements

Power Supply and Motor Specifications

The AC motor used in this saw is a universal, nonreversible type, having the following  

specifications:

Model No.

72905361120

Maximum Developed HP

3

Voltage

120, 60Hz

Amps

15

Hertz (Cycles)

60

Phase

Single

RPM

1300

Shaft Rotation 

Counter-Clockwise

Power Connections

A separate electrical circuit should be used for your tools. This circuit should not be less #12 wire 

and should be protected with a 20 Amp fuse. Have a certified electrician replace or repair a worn 

cord immediately and connect the motor as nameplate mentions. Running low voltage will damage 

the motor. 

WARNING: DO NOT EXPOSE THE TOOL TO RAIN OR OPERATE IN DAMP  

CONDITIONS.

ASSEMBLY AND ADJUSTMENT INSTRUCTIONS

WARNING:

For your own safety, never connect the plug to a power source outlet until all assembly steps  

are complete and you have read and understood the safety and operating instructions. The  

safety guards are attached to the saw for your protection. Should the guards become  

damaged, do not use the saw until damaged cover has been replaced. If the guards  

become dirty, or chips adhere to it, clean the safety guards carefully with a damp cloth.

Unpacking Contents

WARNING:

To avoid injury from unexpected starting or electrical shock, don’t plug the power cord into a  

power source outlet duing unpacking and assembly.  This cord must remain unplugged    

whenever you are working on the saw.

Your saw is shipped complete in one box.

WARNING:

Although compact, this saw is heavy.  To avoid back injury, get help whenever you   

have to lift the saw.