14
en
Filling the removed coolant tank. (Fig. 5).
➤
Pull the empty coolant tank out of drill
stand housing of the magnetic base drill.
➤
Unscrew the bottom closing cap from
the coolant tank.
➤
Fill in pump-feedable water soluble
Slugger Cutting Fluid.
Do not use oil!
➤
Firmly screw the bottom closing cap
back on to the coolant tank.
➤
Insert the filled coolant tank into the
holder on the drill stand housing inten-
ded for this purpose.
Fig. 5
Coolant container
Bottom closing cap
3 41 01 169 21 0.book Seite 14 Mittwoch, 7. September 2011 3:32 15
