25
en
Instructions for core drilling.
Only remove the cutting tool from the hole
while the motor is running.
If the carbide tipped cutter should remain
stuck in the material, stop the drill motor and
carefully turn the carbide tipped cutter out
counterclockwise.
After each drilling operation, remove the
chips and the slug.
Do not touch the chips with your bare
hand. Always use a chip hook.
Danger of burns! The surface
of the magnet can reach high
temperatures. Do not touch the magnet with
your bare hands.
For core drilling in layered material, use a suit-
able Slugger ID cutter.
When changing a cutting tool, pay attention
not to damage the cutting edges.
When core drilling layered material, remove
the core and the chips after having drilled
through each layer.
CAUTION
Error message/
Response of magnet
button
Meaning
Corrective action
Indicator lights up
green
Magnetic holding power is
sufficient.
Indicator flashes
green
Magnetic holding power
possibly insufficient.
Even when working on steel materi-
als where the material thickness is
below 12 mm, the workpiece must
be made thicker with an additional
steel plate in order to ensure the
magnetic holding power.
Indicator lights up red
for 1 second
–
Motion sensor has actuated
–
Overload shut-off has
actuated
–
Incorrect mains voltage
After malfunction correction, the
power tool can be switched on again.
Indicator flashes red
3 x
No speed signal
If the error occurs frequently, send
the machine to your Slugger cus-
tomer service agent.
Indicator lights up red
continuously
–
Incorrect mains voltage/
mains frequency
–
Drill stand is overheated
–
Button is blocked when
switching on
After malfunction correction, the
power tool can be switched on again.
If the error occurs frequently, send
the machine to your Slugger cus-
tomer service agent.
Indicator flashes red
continuously
Power tool is defective.
Send the machine to your Slugger
customer service agent
OBJ_BUCH-0000000261-003.book Page 25 Thursday, January 11, 2018 5:30 PM
