Ref : 26702 14 07/01/15
PART 3 : Starting the ARIANE 3 card
When the parameter setting of the door configuration with respect to
the controller is confirmed, the ARIANE 3 card can enter in operation.
Move the car to a floor in order to have a landing door
associated with the car door.
MECHANICAL EFFICIENCY CHECK
Use the
CMD3
function to run the motor at a slow opening and
closing speed by proceeding as follows :
Scroll the menus by successively pressing
and select
CMD
by
pressing
.
Scroll the CMD functions with
up to CMD3
To start the CMD3 function, press
To operate the motor in opening, press
To operate the motor in closing, press
To exit from the CMD3 command, press
Make sure that the motor rotates in the right direction. If not, return
to the parameters and change the
SMot
parameter.
Make sure that the door operates correctly mechanically from end
stop to end stop and that the skate correctly unlocks the landing door.
OPERATOR TRAVEL LEARNING
Start the travel learning with the
CMD1
command.
Scroll the menus by successively pressing
and select
CMD
by
pressing
.
Scroll the CMD functions with
up to CMD1
To start the CMD1 function, press
The door opens up to the end stop, waits a few seconds to confirm its
0 position, and then closes until the skate is completely closed and
waits a few seconds to confirm the travel value.
When the learning is finished, the card automatically exits from the
CMD1 command and waits for controller orders.
THE DOOR IS READY TO OPERATE