Ref : 26702 18 07/01/15
PART 5 : Saving the parameters
The ARIANE card uses a list of so-called
work
parameters to operate;
these parameters correspond to those which can be read and changed.
The
configuration
parameters: MSTO, MSTF, etc.
The
operating
values:
FP-O, FF-O, etc.
The
manufacturer
parameters: Hidden in use
After the door’s operation has been adjusted, all these values may be
saved to a "save" list by the "SAVE" function so that this adjustment may
be restored at any time with the
INIT
function.
,,,
Multifunction relay no. 2
rMF2
Operator type
tyPE
Cabin cell connected
CELL
Glazed door
Vitr
Motor direction Smot
Limit switches stops directionFdC
Shock signal direction
CHoC
Shock management mode
ModE
Hold under open voltage
Msto
Hold under close voltage
MstF
Opening Cruise frequency
FP-O
End Of Opening frequency
FF-O
Opening Sabre frequency
FS-O
,,,
IN xx
INIT
List N°1
List N°2
Work parameters
Saved adjusted list
List N°3
List N°…
SAVE
TABLES OF STORED FACTORY VALUES
USED VALUE TABLE
SAVED SITE
CLASSIFIED BY DOOR TYPE
CAN BE READ AND CHANGED
PARAMETERS TABLE
To avoid an accidental backup, the "SAVE" instruction is only
accessible in manufacturer mode in the
PINI
configuration
parameter.
To go into manufacturer mode and make a save :
1.
Switch off the card power and wait for the relays to
break
2.
Press and hold the
and "
keys
3.
Still holding the keys, switch power on again
4.
When "FP-O" is displayed, release the keys. You are in
manufacturer
mode
5.
Scroll the parameters with
up to
PINI
6.
Press
to validate the choice
7.
To reach the
SAVE
function, press
8.
To make a save, press
9.
Simultaneously press
and
to confirm the save
