2 Safety
SMA Solar Technology AG
Installation Manual
EDMM-WAGO-IO-IA-en-11
8
NOTICE
Damage to the product due to condensation
If the product is moved from a cold environment to a warm environment, condensation may form in the product. This
can damage the product or impair its functionality.
• When there are large temperature differences, wait until the product has reached room temperature to connect
the voltage supply.
• Make sure the product is dry.
NOTICE
Damage to electronic components due to electrostatic discharge
Electrostatic discharge can damage or destroy electronic components.
• Observe the ESD safety regulations when working on the product.
• Wear suitable personal protective equipment for all work on the product.
• Discharge electrostatic charge by touching grounded elements. Only then is it safe to touch electronic
components.
NOTICE
Damage to the product due to cleaning agents
The use of cleaning agents may cause damage to the product and its components.
• Clean the product and any dirty contacts on the product with Propanol.
• Do not treat dirty contacts on the product with contact cleaners.
DHCP Server is recommended.
The DCHP server automatically assigns the appropriate network settings to your nodes in the local network. A
manual network configuration is therefore not necessary. In a local network, the Internet router is usually the
DHCP server. If the IP addresses in the local network are to be assigned dynamically, DHCP must be activated in
the Internet router (see the Internet router manual). In order to receive the same IP address by the internet router
after a restart, set the MAC address binding.
In networks where no DHCP server is active, proper IP addresses must be assigned from the free address pool of
the network segment to all network participants to be integrated during commissioning.
Summary of Contents for Modbus EDMM-10
Page 54: ...www SMA Solar com...
