8 Operation
SMA Solar Technology AG
Operating manual
111
SI44M-80H-13-BE-en-15
Position
Designation
Description
E
State of charge
Chronological sequence of the state of charge (SOC) of the battery
F
Status display
The various areas display information on the current status of the sys-
tem.
•
Device status
Displays whether the inverter and/or the battery is/are currently
in a fault-free operating state or whether there is an event type
Error
or
Warning
present.
•
Feed-in management
Displays whether the inverter is currently limiting its active
power.
•
Nominal energy throughput of the battery
Indicates how much energy has been charged to the battery
and how much has been discharged from the battery.
•
Battery
Displays the following information:
– Operating status of battery
– Current battery state of charge
– Current battery charging power
•
Energy exchange at the grid-connection point
Indicates how much energy was obtained from the utility grid to
supply the household and how much the PV system fed in.
•
Power at the grid-connection point
Indicates which power is currently fed in or obtained at the grid-
connection point.
•
MC-status system
Status of the multicluster system
•
MC system total power
Total active power of all Sunny Island inverters in the multicluster
system
8.4
Changing the Password
The password for the product can be changed for both user groups. Furthermore, the user group
Installer
can change
the password for the user group
User
as well as its own password.
PV systems registered in a communication product
With PV systems that are registered in a communication product (e.g. Sunny Portal, Sunny Home Manager), you
can also assign a new password for the user group
Installer
via the communication product. The password for
the user group
Installer
is also the system password. If you assign a password for the user group
Installer
via
the user interface of the inverter that does not correspond to the system password in the communication product,
the inverter can no longer be reached by the communication product.
• Ensure that the password for the user group
Installer
is the same as the system password in the
communication product.
