SMA Solar Technology AG
4 Replacing the Display (SB xx00TL-20 and STP xx000TL-10)
Service Manual
STPTL10-SBTL20-Display-AT-SG-de_en-12
13
Installing the New Display
1. Place the new display on the retainer. Ensure that
the display snaps into the lower locking tabs and
rests on the upper locking tabs.
2. Install the display assembly with the new display:
• Slide the display assembly into the left-hand
retainer.
• Press the right-hand retainer outwards and
insert the display assembly into the right-hand
retainer.
• Press the display assembly into both retainers
until it snaps into place.
3. Flip the display assembly down.
4. Tighten the display assembly screw.
5. For each ribbon cable, insert the plug into the
corresponding pin connector while pressing apart
the lock hooks on the pin connector.
6. Ensure that the lock hooks on each pin connector have been closed.
