Mounting
SMA America, LLC
24
SB8-10TL-IUS103811
Installation Guide
6. Insert the screws through the holes in the wall mounting bracket and into the drill holes.
7. Tighten the screws clockwise until the bracket is held firmly against the wall. Do not overtighten
the screws.
☑ The wall mounting bracket is mounted.
Tip for installing
The diameter of the holes you drill must match the hardware you are using to mount the
Sunny Boy.
For example, if you are mounting the Sunny Boy to a concrete wall, the hole diameter
should be approximately the same as the outside diameter of the concrete anchors you
intend to use. If you are mounting the Sunny Boy on a wall that has wooden studs inside it,
the hole diameter must be the correct size for the lag screws you intend to use to mount the
bracket. It is recommended that the lag screws be made of stainless steel, and the diameter
of the screws closely match the diameter of the holes in the wall-mounting bracket. Make
sure that the screws are long enough to penetrate the wall to a depth of 1
1
⁄
2
in.
