Decommissioning
SMA America, LLC
58
SB8-10TL-IUS103811
Installation Guide
11 Decommissioning
11.1 Disassembling the Sunny Boy and SMA DC Disconnect
1. Open the Sunny Boy as described in section 8.1 ”Opening the Sunny Boy” (page 48).
2. Remove all connector cables from the Sunny Boy.
3. Close the Sunny Boy with the six screws and the corresponding washers.
4. Open the SMA DC Disconnect as described in section 8.3 ”Opening SMA DC Disconnect”
5. Open the terminals and remove all cables from the SMA DC Disconnect.
CAUTION
Falling of the Sunny Boy may cause injuries.
Crushing of body parts will result.
• Take the weight of the Sunny Boy into account when dismounting.
6. Remove both screws on the left and right side of the
Sunny Boy that attach it to the wall mounting
bracket.
7. Remove the Sunny Boy upwards in a vertical position
from the wall mounting bracket.
8. Transport the Sunny Boy between two persons, using
the side handles above and below.
or
Put a steel bar with a maximum diameter of 1
1
⁄
8
in.
(30 mm) through the enclosure opening above and
transport it between two people.
