6 Mounting
SMA Solar Technology AG
Operating manual
SB55-LV-JP-41-BE-en-13
25
Procedure:
1. Align the wall mounting bracket horizontally on the
wall and mark the position of the drill holes. Use at
least one hole on the right- and left-hand side and
the lower hole in the middle of the wall mounting
bracket. Tip: When mounting on a post, use the
upper and lower central holes of the wall mounting
bracket.
UP
2. Set the wall mounting bracket aside and drill the marked holes.
3. Insert screw anchors into the drill holes if the support surface requires them.
4. Secure the wall mounting bracket horizontally using
screws and washers.
UP
5. Hook the inverter into the wall mounting bracket.
When doing so, the two right- and left-hand keys on
the ribs on the rear side of the inverter must be
hooked into the respective keyways in the wall
mounting bracket.
UP
6. Ensure that the inverter is securely in place.
7. Secure the inverter to the wall mounting bracket on
both sides with a pan head screw (M5x12)
provided and a washer (M5). Insert a screw into the
lower screw hole of the inverter's anchorage bracket
and tighten it (PH2, torque: 2.5 Nm).
2x
