Procedure:
1. Insert the SD memory card into the SD memory card slot (see Section 7.2.1, page 37).
2. Wait until the message
UPDATE AVAILABLE
appears. This can take up to two minutes.
3. Confirm the question
UPDATE AVAILABLE Start update now ?
with
YES
.
☑ The Sunny Island switches to standby and updates the firmware.
7.3.3
Updating the Firmware Using Sunny Explorer
Automatic Sunny Island inverter start
If the Sunny Island was in operation before the firmware update, the Sunny Island restarts automatically upon
completion of the firmware update.
Using Sunny Explorer, transfer the firmware update to the SMA Speedwire data module Sunny Island. Then, the SMA
Speedwire data module Sunny Island automatically transfers the firmware update to the SD memory card in the
Sunny Remote Control. This transfer takes some time.
Requirements:
☐ The SMA Speedwire data module Sunny Island of the type SWDMSI-NR10 with firmware version 1.01.06.R or
higher must be installed in the system.
☐ A computer with Sunny Explorer and the current firmware must be available.
☐ The Sunny Remote Control must be connected to the master.
Procedure:
1. Ensure that a writable SD memory card is inserted in the Sunny Remote Control and remains inserted throughout
the entire update.
2. Switch to installer mode on the Sunny Remote Control (see Section 5.4.1, page 32).
3. Set the parameter
250.32 UpdMode
to
Auto
.
4. Set the parameter
250.33 UpdAutoTime
to the desired firmware update time.
5. Transfer the firmware update from the computer to the Sunny Island using Sunny Explorer (see the Sunny Explorer
user manual).
6. Once the transfer is complete, close Sunny Explorer.
☑ Once the transfer to the SD memory card is complete, the Sunny Island updates automatically at the specified
time. The Sunny Island switches to standby mode and updates the firmware.
7.3.4
Performing a Remote Update Using the Sunny Home Manager
Automatic Sunny Island inverter start
If the Sunny Island was in operation before the firmware update, the Sunny Island restarts automatically upon
completion of the firmware update.
The Sunny Home Manager can automatically make the current firmware available via Sunny Portal. For this, the
Sunny Home Manager first transfers the firmware update to the SMA Speedwire data module Sunny Island. Then, the
SMA Speedwire data module Sunny Island automatically transfers the firmware update to the SD memory card in the
Sunny Remote Control. This transfer takes some time.
Requirements:
☐ The Sunny Island must be registered in Sunny Portal.
☐ The SMA Speedwire data module Sunny Island of the type SWDMSI-NR10 must be installed in the system.
☐ The Sunny Home Manager must be integrated in the system.
☐ The Sunny Remote Control must be connected to the master.
7 Data Storage and Firmware Update
SMA Solar Technology AG
Operating Manual
41
SI30M-44M-60H-80H-BE-en-33
Summary of Contents for SUNNY ISLAND 3.0M
Page 163: ......
Page 164: ...www SMA Solar com...
