SMA America, LLC
10 Operation
Technical description
SI4548_6048-US-TB_en-13
91
10.7 Parameter Display
Parameters on the Sunny Island are displayed as follows:
In the upper line, the parameter number comes first, then
a separator (hash) followed by the parameter name. In
the lower line, there is the value with the unit and the
modification mark (enter arrow) is on the far right.
Warning message is displayed (at position (H):
This symbol blinks until you have confirmed the warning or the error in the menu
"410# Failures Current" or "420# Failure History".
Display "Generator Status" and "Request Reason"
The two displays above are cyclically shown on the display as the status of the external source.
Example:
If the display changes every three seconds from "*" to "B", this means that the generator voltage
and frequency lie within the set limits and that the generator was requested as a result of the
battery state of charge.
Stopping the generator manually
If the generator has been manually stopped, no generator status information is displayed.
The field remains empty in this case.
Indications of a warning
If faults occur, the device switches into standby mode and shows the fault on the display.
The fault must be eliminated and confirmed, then the Sunny Island carries out an autostart.
Parameter/value list
If you would like to switch from a menu (regardless of whether it is a main or sub-menu) into a
parameter/value list, the menu numbers are not included on the display.
Syntax for menus and parameters
The syntax specified here for menus and parameters applies throughout the entire document.
A menu is identified by the number of the menu, the hash and the name of the menu
(e.g. 120# Battery Meters).
A parameter is labeled with the menu number, dot, the parameter number and parameter name
(120.02 BatVtg).
Symbol
Meaning
Summary of Contents for Sunny Island 4548-US
Page 2: ......
Page 14: ......
Page 240: ...www SMA Solar com SMA Solar Technology SMA America LLC www SMA America com...
