SMA America, LLC
2 Sunny Island 4548-US/6048-US
Technical description
SI4548_6048-US-TB_en-13
25
2.4 Required Tools and Resources
The following tools and materials are required in order to mount and install the
Sunny Island 4548-US/6048-US:
2.5 Identifying the Sunny Island
Identify the Sunny Island by the serial number (Serial No.) and the device type (Type) on the type
label. The type label is located on the right-hand side of the enclosure.
Tools (not included in scope of delivery)
Cable knife
Combination pliers
Crimping tool for bootlace ferrules (suitable for cable cross-sections up to 3/0 AWG)
Diagonal cutting pliers
Drill
Drill bit (e.g. for masonry or wood), fastener
3
/
8
in. or Ø 10 mm
Flat-blade screwdriver
3
⁄
32
in. (2.5 mm)
Flat-blade screwdriver SZS 1.0 x 6.5
Allen key
1
⁄
8
in. to
5
⁄
16
in. (3 mm to 8 mm)
Multimeter
Open-end/box wrenches or socket wrenches in the sizes 10/19/24/30
Philips screwdriver, PH1 and PH2
Spirit level
Torque wrench 4 ft-lbs. to 21 ft-lbs. (6 Nm to 28 Nm) with hexagon socket screwdriver bit in the sizes
3
⁄
16
in. (5 mm) and
3
⁄
8
in. (10 mm)
Torque wrench 5 in-lbs. to 22 in-lbs. (0.56 Nm to 2.5 Nm) with flat-blade screwdriver bits in the sizes
3
⁄
32
in. (2.5 mm) and flat-blade screwdriver SZS 1.0 x 6.5
Insulation stripping tool
Material (not included in scope of delivery)
Cable tie
Heat-shrink tubing
Hexagon screws,
5
/
16
in. x 2
3
/
8
in. (8 mm x 60 mm)
Washers
Screw anchor for the wall mounting bracket (e.g. SX 10)
Bootlace ferrules appropriate for the selected cable (see Section 6 "Electrical Connection", page 37)
Summary of Contents for Sunny Island 4548-US
Page 2: ......
Page 14: ......
Page 240: ...www SMA Solar com SMA Solar Technology SMA America LLC www SMA America com...
