SMA Solar Technology AG
4 Operating the Off-Grid Inverter with Sunny Remote Control
Operating Manual
SI80H-BE-BEN120810
35
4.4.6 Setting the Parameters
Always set parameters as described below.
1. Switch to installer mode (see Section 4.4.1).
2. Select the desired parameter. You can only set the
parameters for which
< Set >
is shown in the
second line in the display.
3. Press the button.
☑ The return icon flashes next to the value.
✖ The display shows:
Stop device to change the value
?
The parameter can only be changed in standby mode.
• Stop the off-grid system (see Section 5.3).
✖ The display shows:
No permission to change the value
.
You are not allowed to change the parameter in installer mode.
• If you want to change the parameters for the battery, select the
New Battery
menu in
the QCG (see Section 9.8 "Replacing the Battery", page 52).
• If you want to change the addresses of the slaves in a cluster, select the
New Clst Cfg
menu in the QCG (see Section 10.4).
• For all other settings in the QCG, select the
New System
menu (see the installation
manual of the off-grid inverter).
4. To set the parameter, turn the button to the left or right.
5. Press the button.
☑ The Sunny Remote Control requests
confirmation of the parameter set.
6. To confirm the value, turn the button to the right until
Y
flashes and then push the button.
7. To discard the value
,
turn the button to the right until
N
flashes and then press the button.
