SMA Solar Technology AG
6 Saving Data and Updating Firmware
Operating Manual
SI80H-BE-BEN120810
41
6 Saving Data and Updating Firmware
6.1 Inserting the SD Card
Requirements:
☐ The SD card must be formatted as FAT-16.
☐ The storage capacity of the SD card must not exceed 2 GB.
☐ The SD card must only be used as a data medium for the off-grid system.
• Insert the SD card, with the slanted corner facing
upwards, into the SD card slot in the Sunny Remote
Control. The label on the SD card must point to the
front.
6.2 Saving and Loading Parameters
You can load and save the current parameter settings in two different parameter sets on the SD card.
The two parameter sets are distinguished by the Sunny Remote Control in
Set1
and
Set2
. Every
parameter set saves all settings. This makes it possible to test the settings of a new parameter set
without having to delete the old parameter set. Hint: As soon as you have set up a functional off-grid
system, save the parameter settings to the SD card. After saving, you can further adjust the off-grid
system. If the adjustment does not lead to the desired results, reload the saved parameter set.
Requirement:
☐ The SD card must be inserted.
1. Switch to installer mode (see Section 4.4.1).
2. To save a parameter set, select the parameter
550.01 ParaSto
and set the parameter:
Value
Explanation
Set 1
Save the settings in the first parameter set.
Set 2
Save the settings in the second parameter set.
