9 Operation
SMA Solar Technology AG
Operating Manual
STPx0-3SE-40-BE-en-10
75
Layout of the installation assistant
A
C
B
Figure 21: Layout of the installation assistant (example)
Position
Designation
Description
A
Configuration steps
Overview of the installation assistant steps. The number of
steps depends on the type of device and the additionally
installed modules. The current step is highlighted in blue.
B
User information
Information about the current configuration step and the
setting options of the configuration step.
C
Configuration field
You can make settings in this field.
Procedure:
1. Open the user interface (see Section 9.1, page 66).
2. Log in as
Installer
.
3. Select the menu
User Settings
(see Section 9.3, page 71) on the start page of the user
interface.
4. In the context menu, select [
Starting the installation assistant
].
☑ The installation assistant will open.
9.7
Switching WLAN On and Off
The inverter is equipped with an activated WLAN interface as standard. If you do not want to use
WLAN, you can switch the WLAN function off and switch it on again whenever needed. In doing
so, you can switch the WLAN direct connection and the WLAN connection in the local network on
independently of each other.
Switching on the WLAN function only possible via Ethernet connection
If you switch off both the WLAN function for the direct connection and for the connection in
the local network, access to the inverter user interface and therefore reactivation of the WLAN
interface is only possible via an Ethernet connection.
Summary of Contents for SUNNY TRIPOWER 10.0 SMART ENERGY
Page 132: ...www SMA Solar com...
