Display
SMA Solar Technology AG
12
WB5A-6A-BA-BEN114530
User Manual
4 Display
4.1 Operation
The display shows the current values of your plant. The displayed values are updated every
5 seconds.
You can operate the display by tapping the enclosure lid:
Single tap:
The backlight switches on or the display scrolls one message further.
2 taps in quick succession (valid from firmware version 2.18):
The inverter successively displays the device type, the firmware version, the configured country setting
and the configuration of the SMA Power Balancer.
4.2 Display Messages during Operation
After commissioning, the inverter successively displays the device type, the firmware version, the
configured country setting and the configuration of the SMA Power Balancer. If you want to view
again the display messages of the startup phase while in operation, double tap the enclosure lid
(from firmware version 2.18).
Upon error-free connection of the inverter to the power distribution grid, after approximately one
minute, the display starts alternating between the messages shown below. Each message appears for
5 seconds, and then the cycle restarts from the beginning.
Display message
Description
Inverter device type
Firmware version of internal processors
Configured country standard of inverter
(example: "GER/VDE0126-1-1")
Configuration of the SMA Power Balancer
(Example: "PowerGuard")
PowerBalancer
PowerGuard
Summary of Contents for WINDY BOY 5000A
Page 2: ......
Page 4: ...Table of Contents SMA Solar Technology AG 4 WB5A 6A BA BEN114530 User Manual...
Page 21: ......
Page 22: ......
