9
Make corresponding settings on PS2016-DAQ Lite, as shown in Figure 6, with detailed notes
below.
1
：
Select the correct serial port connection.
2
：
Set the sampling cycle in seconds.
3
：
Set the range. Can be set as 20V or 200V range when measuring voltage signals.
4
：
Set the path of data storage.
5
：
Choose the channel to run the DAQ device in.
Figure 5
、
Voltage signal test connection
Attention ： When measuring voltage signals, if the thermocouple range is
selected by mistake, the PS2016 DAQ device may be damaged after it runs.
