FY500 HART – Operation, Maintenance, and Installation Manual
5.2
Identification and Manufacturing Data
The following information about the
FY500
manufacturing and identification data is available:
TAG
8-character alphanumeric field for identification of the positioner.
DESCRIPTION
16-character alphanumeric field for additional identification of the positioner. May be used to identify
service or location.
MESSAGE
32-character alphanumeric field for any other information, such as the name of the person who
made the last calibration, some special care to be taken, or if a ladder is needed for physical access
to the positioner.
DATE
The date may be used to identify a relevant date, such as the last calibration, the next calibration, or
the installation. The date is stored in the American standard e.g.: Oct 16, 2022) and is automatically
assumed after the choice of these items.
UNIQUE ID
Used to identify the device and in the construction of the HART long form address.
DEVICE INFORMATION
Allows to read the equipment identification data recorded in the factory.
NOTE
These items related to
EQUIPMENT INFORMATION
, engraved in the factory cannot be modified.
They are read directly from the circuit memory.
Monitoring
This function allows remote monitoring of positioner variables. The time to start the reading is
around 5 seconds. The values are always updated. Among others, some of the variables that can
be monitored are: valve actual position in percentage, input in percentage of the adjusted current
range (before the flow limits and linearization), input current in mA or %, device temperature in
Celsius and in Fahrenheit degrees, etc.
Device Configuration
NOTE
WRITE PROTECTION
– The configurator only shows that the writing is authorized if the
W1
jumper
from main board
is connected to the pins over the word
ON
or if the protection is enabled
by software.
Besides the equipment configuration and operation services, the
FY500
allows Auto Setup
(Calibration) and Auto Tuning. See below the configuration options:
-
CHARACTERIZATION FUNCTION
This function can change valve flow characteristics. For example, if an equal percentage
flow characterization is applied to a valve with linear flow characteristics, it will work as an
equal percentage valve. Manufacturer documentation contains the valve inherent
characteristic. The options for flow characterization are:
Summary of Contents for HART FY500
