Medi-Minder Installation Manual Rev1.11
17
6.2.10
CELLULAR Programming Options (Medi-Minder 3G Version Only)
Cellular Identity
NB: Cannot be changed but are there for your reference only eg. 359769123456789
Cellular Type
NB: Cannot be changed but are there for your reference only eg. SIMCOMSIM5216J
Cellular Revision
NB: Cannot be changed but are there for your reference only eg. 1575B06SIM5216
SIM Identity
NB: Cannot be changed but are there for your reference only eg. 89610106069123456789
SIM Provider
NB: Cannot be changed but are there for your reference only eg. Telstra Mobile
SIM APN
“SA” is displayed. Press the Help Button to View Programmed digits.
Pressing the Help Button again to program each digits eg. telstra.2m2 or telstra.internet
Cellular Poll Time (default 60 = 60 minutes)
“Pt” is displayed. Press the Help Button to View Programmed digits (0 to 255 Minutes).
To change the Cellular Poll Time, Pressing the Help Button to scroll through digits 0, 1, 2 , 3, 4, 5, 6, 7,
8, & 9
To Store an option selected, press the CANCEL and HELP Buttons at the same time. The unit will beep
twice while flashing the display to acknowledge that the option has been selected.
Cellular Mode (default 5 = MediLink Setting) refer SmartLink
Cellular In Level (default 0) refer SmartLink
Cellular In Attenuation (default 255) refer SmartLink
Cellular Out Level (default 0) refer SmartLink
Cellular Out Attenuation (default 136) refer SmartLink
Cellular Sidetone Gain (default 16) refer SmartLink
Network AMR (default d = Disabled) refer SmartLink
Network Rate (default 1 = Full Rate Preferred) refer SmartLink
Cellular Signal Quality
“SL” is displayed.
Press the Help Button and the unit displays the Cellular Signal Quality from 1 to 31
(10 to 31 good, 6 to 9 average, below 6 may need relocation or alternate Carrier)
Default Values –
Sets all CELLULAR Programming Options to Default Values
Warning! This will Sets all Timers Programming Options to Default Values
“
dF
” is displayed. Press the CANCEL and HELP Buttons at the same time and the unit will beeps three times
to indicate that ALL CELLULAR Programming Options have been defaulted.
Press the CANCEL Button to move to the next Program Option.
