Medi-Minder Installation Manual Rev1.11
8
6.2.3
SERVER Programming Options (Medi-Minder 3G Version Only)
Note: The easiest way to program the
SERVER Programming Options is to use the
SmartLink Up/Download Programmer Software (MediMinder)
Server 1 IP Address - (up to 30 Digits/Characters Maximum)
Note: Programmed as the first Digit will delete Server 1 URL
to
Digits - 0 to 9
Dot
to
Characters - A to Z and a to z
1.
“
_N
” is displayed. Press the HELP Button.
2.
“
S1
” is displayed. Press the HELP Button again to view programmed
Server 1 IP Address
. The
programmed Server 1 IP Address will be flashed on status display. If you wish to view the Server 1 IP
Address again, press the CANCEL and then HELP Button. “ -” is displayed and flashes on the unit.
3.
Pressing the HELP Button again to step through the digits (
0, 1, 2, 3, 4, 5, 6, 7, 8, 9, 0, ., A
to
Z
). To
STORE
each digit, press the CANCEL and HELP Buttons at the same time to store each digit. The unit
will beep twice and display the next digit to be programmed. Repeat this process until all digits are
programmed.
4.
Press the CANCEL Button to display the programmed Server 1 IP Address stored. The unit will be
flashed on status display for each digit and beeps twice at the end of the Server 1 IP Address stored.
5.
Press the CANCEL Button to move to the next Program Option.
Server 1 Port Number - (up to 5 Digits Maximum)
Note: Programmed as the first Digit will delete Server 1 Port Number
to
Digits - 0 to 9
6.
“
P1
” is displayed. Press the HELP Button.
7.
“
-
” is displayed. Press the HELP Button again to view programmed
Server 1 Port Number
. The
programmed Server 1 Port Number will be flashed on status display. If you wish to view the Server 1 Port
Number again, press the CANCEL and then HELP Button. “ -” is displayed and flashes on the unit.
8.
Pressing the HELP Button again to step through the digits (
0, 1, 2, 3, 4, 5, 6, 7, 8,
and
9
). To
STORE
each digit, press the CANCEL and HELP Buttons at the same time to store each digit. The unit will beep
twice and display the next digit to be programmed. Repeat this process until
all digits are programmed.
9.
Press the CANCEL Button to display the programmed Server 1 Port Number stored. The unit will be
flashed on status display for each digit and beeps twice at the end of the Server 1 Port Number stored.
10.
Press the CANCEL Button to move to the next Program Option.
Server 2 IP Address - (up to 30 Digits/Characters Maximum)
Server 2 Port Number - (up to 5 Digits Maximum)
Default Values –
Deletes/Erases all the Server Programming to Default Values
Warning! This will Deletes/Erases all Programmed Servers
11.
“
dF
” is displayed. Press the CANCEL and HELP Buttons at the same time and the unit will beeps three
times to indicate that ALL Server Numbers (S1, P1, S2 and P2) have been Erased.
12.
Press the CANCEL Button to move to the next Program Option.
