14
2.
Turn the feeder on then cycle the unit several times to ensure there are no treats in the brushes (quick
press of the power button on the feeder).
3.
Set the feeder on a firm flat surface or on the floor or crate mount.
4.
Simultaneously press and hold the volume and power buttons for about 7 seconds, until the unit beeps
and the power and status lights begin to flash. As soon as you hear the beep and see the lights flash release
both buttons. The unit will automatically cycle the brushes and the status and power lights will continue
to flash for about 30 seconds during the calibration. Do not move the unit or press any buttons during this
time.
5.
Once the calibration is complete, the power light will return to a slow flash. You can then add treats into
the hopper and run a few cycles (quick press of the power button on the feeder) to test the precision of the
dispense.
T
HE
F
LOOR
B
ASE
Item
Description
Bowl
The bowl collects the treats as dispensed by the feeder.
Chase feed
Allows the treats to roll across the floor, into a crate or off a counter or table.
Attachment brackets
Stainless steel brackets hold the feeder in
bowl
or
chase feed
positions
You can set the unit on the Floor Base in two ways: facing the
bowl
or the
chase feed
. The treats shoot out the side
of the feeder where the Pet Tutor
®
logo is facing. While holding the device upright, simply lock it into the locking
brackets with a clockwise quarter turn. The placement of the logo determines if the treats will shoot into the bowl
or the chase feed. The Floor Base can be set on any flat surface.
T
HE
U
NIVERSAL
C
RATE
M
OUNT
Note: The crate mount is under development and coming soon.
