16
C
ARE AND CLEANING
-
Feeder:
Turn the Feeder off and empty the hopper of all the treats. Press on the two locking tabs at the
bottom of the blue feeder tube and gently pull it upward by the handle to unlock the tube from the
electronics module. For easier separation of the blue tube from the electronics module, you may lock the
Pet Tutor
®
into the floor base. Press on the two locking tabs at the top of the blue tube and gently
separate the top end cap from the blue tube. You can hand wash both the blue tube and the end cap. You
may also place the blue tube in the top rack of your dishwasher and hand-wash the end cap separately.
-
Brushes (Feeder)
: Gently pull the brush assembly (see
illustration) off of the electronics module.
DO NOT
ATTEMPT
TO LOOSEN THE STAINLESS STEEL SCREWS ON THE
BRUSHES. You can hand wash the brush assembly or put it in
the top rack of the dishwashers. Once clean, put the
assembly back onto the electronics module, and with the
brushes facing you, align the tabs in the brushes with the
notches in the drive posts on the electronics module. When
aligned gently push the brushes back onto the electronics
module. The brush assembly will easily slip over the posts if
properly aligned. Do not force. ALWAYS CONFIRM THE
BRUSHES ARE DRY BEFORE PLACING THEM ON TO THE
ELECTRONICS MODULE.
-
Electronics module (Feeder):
Make sure the Pet Tutor
®
is turned
off. With a lightly dampened cloth or paper towel wipe off the
stainless steel plate. DO NOT SUBMERGE THE ELECTRONICS
MODULE. WATER WILL DAMAGE THE ELECTRONICS. Dry all parts
thoroughly before reassembling them.
-
Floor base:
Hand wash with warm, soapy water and dry
thoroughly. DO NOT PLACE IN THE DISHWASHER. DO NOT
PUT ON TOP OF A HOT ELEMENT.
-
Crate mount:
Wipe the chute out with a damp cloth.
-
Remote:
Wipe off with hand sanitizing wipe or computer
wipe. AVOID THE MIC AND SPEAKER ON THE REMOTE. DO
NOT LET YOUR PET PLAY WITH THE REMOTE.
