Software Installation & Operation
Inputs/Outputs:
Enter the number of Inputs/Outputs your AVRouter has. For now
we will assume that there are 16 inputs and 16 outputs.
Com Port:
Select the appropriate com port that your computer is using to access
the router.
Router Timeout:
By default this is 0 meaning the computer acknowledges
commands almost instantly. Sometimes a computer takes longer to respond. This
setting should be left at 0. If you need to change it, it should be no higher than 0.2.
After you have entered in the necessary information click OK.
This will now take you to the Main Routing Window where you can route the different
video/audio connections.
On this screen you will notice the input buttons running down the left side while the
output buttons run across the top. They are each labeled 1 through 16.
Note:
The three small colored buttons at the lower right labeled ALL, VIDEO, and
AUDIO are not available if AV Split was not checked when you configured your router.
3
