There are three ways to control
the KVM Switch: Keyboard HotKeys, RS-232
Serial Commands, and Front Panel Buttons.
The settings for the serial connection are as
follows: Baud rate:
115200
; Data Bits:
8
;
Parity:
None
; Stop Bits:
1
; Flow Control:
None
.
The following commands can be used:
Users are able to customize the keys that
trigger Hotkeys. The following keys are
allowed: CT (Left/Right), Alt, Shift (Left/
Right), Caps Lock, Scroll Lock, F1-F12
Change HK Trigger
HK + HK + X + desired hotkey
View Current HK Trigger
Use the RS-232 command: //??<CR>
Default HotKey Trigger
CT (Left)
Chart Key
[CT]
= Ctrl
<CR>
= Carriage Return (Enter Key)
[HK]
= Current Hot Key Trigger
Command
Hotkey
RS-232
Switch KVM
[CT][CT][#]<CR>
//
m
[#]<CR>
Audio Only
[CT][CT]
a
[#]<CR>
//
a
[#]<CR>
KM Only
[CT][CT]
c
[#]<CR>
//
c
[#]<CR>
USB Only
[CT][CT]
u
[#]<CR>
//
u
[#]<CR>
Trigger Hotplug
[CT][CT]
h
<CR>
//
h
<CR>
Restore Factory Defaults
[CT][CT]
f
<CR>
//
f
<CR>
Reset Software
[CT][CT]
r
//
r
<CR>
Get Port Status
N/A
//
??
<CR>
SYSTEM CONTROL
CUSTOM HOTKEY TRIGGERS
DP IN
HDMI OUT
USB IN
USB K/M OUT
USB 2.0 OUT
AUDIO IN
AUDIO OUT
12VDC
2.0A
USB
RS232
K/M
AUDIO
AUDIO
USB
OUT
IN-1
AUDIO
USB
AUDIO
USB
IN-2
AUDIO
USB
DP A
DP
A
IN-1
DP A
DP
A
HD
MI O
UT
A
DP
B
DP
B
DP
B
DP
B
HDM
I OU
T B
HDMI O
UT
A
HDMI O
UT B
HARDWARE INSTALLATION
1. Ensure that power is turned off or disconnected from the unit and the computers.
2. Use Dispay Port cables to connect the Display Port output ports from each computer to the
corresponding Display Port in ports of the unit.
3. Use a USB cable (Type-A to Type-B) to connect a USB port on each computer to the
respective USB ports of the unit.
4. Optionally, connect a stereo audio cable (3.5 mm to 3.5 mm) to connect the audio output of
the computer(s) to the audio in ports of the unit.
5. Connect monitor(s) to the HDMI out console ports of the unit using HDMI cable(s).
6. Connect a USB keyboard and mouse in the two USB console ports.
7. Optionally, connect stereo speakers to the audio out port of the unit.
8. Finally, power on the secure KVM switch by connecting a 12-VDC power supply to the power
connector, and then turn on all the computers.
Note:
You can connect two monitors to the single-head KVM switch and four monitors to the
dual-head KVM switch. The computer connected to port 1 will always be selected by
default after power up.
