SSID and the associated password. The PB-4 supports WPS for automatically
obtaining the SSID and password from the access point which is quick and
easy if the access point also supports this feature. Alternatively, you can
manually enter the credentials by starting the PB-4 in AP mode, loading the
user interface into your browser (as described above), connecting to the PB-4
(click on red button) and then going to Menu / Options / PB-4 Configuration
/ Set Access Point Details.
Once the PB-4 is able to connect to the local network, you can load the user
interface page into the tablet's browser. Again, if MDNS is supported by the
tablet, the host name pb4.local can be used. Otherwise, you need to find out
the IP address that has been assigned to the PB-4 by the access point. Follow
these steps:
1. Turn on the PB-4 in STA mode (press the on/off switch until LED 2 goes
green). When you release the switch, LED 2 will go off and then after a few
seconds will flash green slowly if the PB-4 has successfully managed to
log into the access point.
2. Turn the PB-4 off (press switch until the LEDs go out).
3. Turn the PB-4 on again but this time start it in AP mode (press on/off only
until LED 1 comes on).
4. Access the PB-4 user interface page with your browser as described in the
previous section, connect to the PB-4 (click on red button) and then go to
Menu / About. The about box will contain a line that says STA Mode IP
Address: XX.XX.XX.XX. The address that is shown is the IP address that
has been assigned to the PB-4 by the access point, note it down.
Having found out the PB-4's IP address when in STA mode, you can use that
address to access the user interface page and then add a bookmark for that
page in your browser called something like "PB-4 STA Mode (at home)".
1.2. Initial screen
When you load the PB-4 user interface into your browser, after showing the
splash screen for a few seconds it will show an initial screen, like
This shows a polar chart and a list of captured points (both empty as no points
have been captured yet). At the top of the screen, are the Menu and Connect
buttons and the name of the current job.
Most of the screen is used to display the PB-4 data. At the top of the region
are three tabs (Polar, Spectrum & Data) which you use to select the data you
wish to see.
The polar tab shows a polar chart, a list of captured points and
some buttons. For a detailed description of using the polar tab
Polar
www.smartavionics.com
2
Initial screen
Summary of Contents for PB-4
