A P P E N D I X B
Remotely managing your system through an RS-232 serial interface
72
smarttech.com/kb/170510
Appendix B:
Adjusting projector settings
The remote control’s Menu button enables you to access the on-screen display to adjust the projector
settings.
I M P O R T A N T
Keep your remote control in a safe place because there is no other way to access menu options.
Setting
Use
Notes
Image Adjustment menu
Display Mode
Indicates the projector’s display
output (
SMART Presentation
,
Bright Room
,
Dark Room
,
sRGB
and
User
).
The default is
SMART Presentation
.
Brightness
Adjusts projector brightness
from 0 to 100.
The default is 50.
Contrast
Adjusts the difference between
the lightest and darkest parts
of the image from 0 to 100.
The default is 50.
Frequency
Adjusts the display data
frequency of the projected
image from -5 to 5 to match the
frequency of your computer’s
graphics card.
The default is 0.
This setting applies to VGA inputs only.
Tracking
Synchronizes your projector’s
display timing with your
computer’s graphics card from 0
to 63.
This setting applies to VGA inputs only.
H-Position
Moves the horizontal position of
the source video left or right
from 0 to 100 (relative to the
projected image).
Don’t adjust this setting unless you’re advised
to by SMART Support.
Apply this setting only after you make all
physical adjustments.
This setting applies to VGA inputs only and is
useful in situations where the source video is
cut off.
