A P P E N D I X A
Remotely managing your system through a network interface
53
smarttech.com/kb/170510
Network settings
This menu allows you to use or not use Dynamic Host Control Protocol (DHCP) and to set the
network-related addresses and names when DHCP is not used.
Submenu setting
Description
DHCP
Determines if the projector’s IP address and other network settings
are dynamically assigned by a DHCP server or are manually set.
l
On
allows the network’s DHCP server to assign a dynamic IP
address to the projector.
l
Off
allows you to manually set the projector’s IP address and
other network settings.
IP Address
Displays or allows you to set the projector’s IP address in values
between 0.0.0.0 and 255.255.255.255.
Subnet Mask
Displays or allows you to set the projector’s subnet mask number in
values between 0.0.0.0 and 255.255.255.255.
Gateway
Displays or allows you to set the projector’s default network gateway
in values between 0.0.0.0 and 255.255.255.255.
DNS
Displays or allows you to set the projector’s IP address for your
network’s primary domain name server in values between 0.0.0.0 and
255.255.255.255.
Group Name
Displays or allows you to set the projector’s workgroup name
(maximum 12 characters).
Projector Name
Displays or allows you to set the projector’s name (maximum 12
characters).
Location
Displays or allows you to set the projector’s location (maximum 16
characters).
Contact
Displays or allows you to set the contact name or number for
projector support (maximum 16 characters).
SNMP Enable
Turns the Simple Network Management Protocol (SNMP) agent on or
off.
Read-Only Community
Sets a password that is required for each SNMP get request to
the device.
N O T E
The default for Read-Only Community is public.
Read/Write Community
Sets a password that is required for each SNMP set request to the
device.
N O T E
The default for Read/Write Community is private.
