A P P E N D I X B
Remotely managing your system through an RS-232 serial interface
76
smarttech.com/kb/170510
Setting
Use
Notes
DHCP
Displays the status of the
network’s Dynamic Host
Configuration Protocol (DHCP)
as
On
or
Off
.
The default is on.
On
enables a DHCP server on the network to
automatically assign an IP address to the
projector.
Off
enables an administrator to assign an IP
address manually.
Password
Reminder
E-mails the network password
to the previously defined e-mail
recipient.
See
on page 47 to set
up a destination e-mail address.
IP Address
Displays the projector’s current
IP address in values between
0.0.0.0 and 255.255.255.255.
To change the projector’s IP address, use the
RS-232 connector (see
page 68) or use a DHCP server to assign a
dynamic IP address, and then set a static IP
address using the network remote
management feature (see
your system through a network interface
Subnet Mask
Displays the projector’s subnet
mask number in values between
0.0.0.0 and 255.255.255.255.
Gateway
Displays the projector’s default
network gateway in values
between 0.0.0.0 and
255.255.255.255.
DNS
Displays the projector’s primary
domain name server (DNS) IP
address in values between
0.0.0.0 and 255.255.255.255.
MAC Address
Displays the projector’s MAC
address in xx-xx-xx-xx-xx-xx
format.
Group Name
Displays the projector’s
workgroup name as set by an
administrator (maximum 12
characters).
You can set the projector’s workgroup name
using the remote management features (see
Remotely managing your system through a
network interface
