Connecting your room control system to the ACP
By connecting a computer or room control system to the DB9 connector on the ACP harness cable,
you can select video inputs, start up or shut down your interactive whiteboard system and request
information such as projector lamp use, current settings and network addresses.
Serial interface settings
The serial interface of the SMART UX60 projector acts as a Data Communications Equipment (DCE)
device and its settings can’t be configured. You must configure your computer’s serial
communication program (such as Microsoft® HyperTerminal) or your room control system’s serial
communication settings with the following values:
Setting
Value
Data Rate
19.2 kbps
Data Bits
8
Parity
None
Stop Bits
1
Flow Control
None
N
N O T E S
l
Asynchronous mode is disabled by default in the projector.
l
All commands should be in ASCII format. Terminate all commands with a carriage return.
l
All responses from the projector are terminated with a command prompt. Wait until you
receive the command prompt indicating that the system is ready for another command before
you proceed.
l
The room control feature of the projector is always on.
g
To configure your computer’s serial interface
1. Turn on your computer, and then start your serial communications program or terminal
emulation program.
2. Connect your computer to the serial connection cable you previously connected to the ACP.
A P P E N D I X
A
Remotely managing your interactive whiteboard system
70
