3. Configure your serial interface settings using the values from the table in the previous section,
and then press ENTER.
An “invalid cmd= ? for help” message appears, and the > character appears as a command
prompt on the following line.
N
N O T E
If no message or an error message appears, your serial interface configuration isn’t correct.
Repeat step 3.
4. Type commands to configure your settings.
N
N O T E S
o
To see a list of available commands, type
?
and then press ENTER.
o
If you’re using a terminal emulation program, turn on your program’s local echo setting
to see characters as you type them.
Projector programming commands
This section documents the projector programming commands.
Projector power state controls
SMART UX60 projectors respond to commands only at certain power levels and times.
l
Powering (startup)
l
On (operating)
l
Cooling
Command inventory
SMART UX60 projectors respond to the commands in the tables on the following pages. To see a list
of valid commands in the projector’s current power state, type
?
and press ENTER.
N
N O T E S
l
Send a command only after the projector sends a command prompt.
l
Commands aren’t case sensitive. Type commands exactly as they appear in the left column
of the tables, with the proper value or setting in the center column.
l
Check your entries carefully before entering your commands.
A P P E N D I X
A
Remotely managing your interactive whiteboard system
71
