I M P O R T A N T I N F O R M A T I O N
ii
smarttech.com/kb/170446
l
To prevent personal injury, do not attempt to mount or carry the interactive flat panel using your
own strength. Instead, use a lifting device with the included attachable eyebolts. The eyebolts
are not post-installation hardware.
l
Use only VESA®-approved mounting hardware.
l
Disconnect all power cables for your interactive flat panel from the wall outlet and seek
assistance from qualified service personnel when any of the following occurs:
o
The power cable or plug is damaged
o
Liquid is spilled into the interactive flat panel
o
Objects fall into the interactive flat panel
o
The interactive flat panel is dropped
o
Structural damage such as cracking occurs
o
The interactive flat panel behaves unexpectedly when you follow operating instructions
C A U T I O N
l
Do not install or remove the I/O extension module or an OPS computer while the interactive
flat panel is turned on.
l
Before you clean your SMART product, shut down or disconnect the computer. Otherwise,
you may scramble the desktop icons or inadvertently activate applications when you wipe the
screen.
l
Avoid setting up and using the SMART product in an area with excessive levels of dust,
humidity and smoke.
l
Make sure an electrical socket is near your SMART product and remains easily accessible
during use.
l
The external power supply needs to meet the Limited Power Source (LPS) requirements of
CSA/UL/IEC/EN 60950-1, when required.
l
This SMART product should be used only with European TN and TT power distribution
systems.
It is not suitable for older, IT-type power distribution systems found in some European
countries. "This system (IT-type) is widely used isolated from earth, in some installations in
France, with impedance to earth, at 230/400V, and in Norway, with voltage limiter, neutral not
distributed, at 230V line-to-line." (IEC 60950:1999)
Contact qualified personnel if you’re uncertain of the type of power system available where
you’re installing your SMART product.
