C H A P T E R 5
Using your interactive flat panel
34
smarttech.com/kb/170446
4. Press the
Input Select
button
on the front control panel until the input source is HDMI2.
T I P
Alternatively, you can press the
button on the remote control (see
To connect a guest laptop to the DVI-D input source (SMART Board 8084i-G4-SMP
interactive flat panels only)
1. Connect the USB cable from the interactive flat panel’s USB3 receptacle to the guest laptop.
2. Connect the DVI cable from the interactive flat panel’s DVI-D connector to the guest laptop.
3. Turn on the laptop.
4. Press the
Input Select
button
on the front control panel until the input source is DVI-D.
T I P
Alternatively, you can press the
button on the remote control (see
Connecting a guest laptop through a SMART GoWire cable
If you want to connect a laptop that doesn’t have SMART software installed, you can use a
SMART GoWire cable. The SMART GoWire cable enables you to have touch control of the laptop
and use SMART Meeting Pro PE software without installing the software on the laptop.
I M P O R T A N T
Your interactive flat panel supports the SMART GoWire cable with SMART Meeting Pro PE
software only. It does not support the SMART GoWire cable with SMART Notebook™
collaborative learning software.
To connect a SMART GoWire cable
1. Connect the guest laptop to the interactive flat panel as described in
