C H A P T E R 6
Maintaining your interactive flat panel
50
smarttech.com/kb/170446
Preventing condensation
Your interactive flat panel screen contains layers of glass that can collect condensation, especially in
the following conditions:
l
Temperature extremes with high humidity
l
Rapid changes in humidity, which can occur when you operate the product near water, such as a
sink, pool, kettle or air conditioner ventilator
l
Direct exposure to sunlight
To evaporate condensation from your interactive flat panel
1. Remove the humidity source from the interactive flat panel, if possible.
2. Adjust the room temperature to normal operating ranges.
3. Turn on the interactive flat panel for 2–3 hours.
4. If the screen condensation doesn’t evaporate, contact SMART Support
).
Checking the interactive flat panel installation
Inspect your interactive flat panel installation frequently to ensure that it remains securely installed.
l
Check the mounting location for signs of damage or weakness that can occur over time.
l
Check for loose screws, gaps, distortions or other issues that could occur with the mounting
apparatus.
If you find an issue, refer to a professional installer.
Removing your interactive flat panel
To safely remove your interactive flat panel, use four or more professional installers.
W A R N I N G
l
Do not attempt to move the interactive flat panel using your own strength. The interactive flat
panel is very heavy.
l
Do not move the interactive flat panel by connecting a rope or wire to the handles on the back.
The interactive flat panel can fall and cause personal injury and product damage.
