These commands control the appearance of your source. These settings are unavailable when the
projector is in Standby mode or when the source is disconnected. See
on page 65 for setting absolute and adjustment commands.
Command
Command target range
Response
set displaymode [target]
=SMART Presentation
=Bright Classroom
=Dark Classroom
=sRGB
=User
displaymode=[target]
set brightness [value]
=0 to =100
brightness=[value]
set contrast [value]
=0 to =100
contrast=[value]
set whitepeaking [value]
=0 to =10
whitepeaking=[value]
set degamma [value]
=0 to =3
degamma=[value]
set red [value]
=0 to =100
red=[value]
set green [value]
=0 to =100
green=[value]
set blue [value]
=0 to =100
blue=[value]
set cyan [value]
=0 to =100
cyan=[value]
set magenta [value]
=0 to =100
magenta=[value]
set yellow [value]
=0 to =100
yellow=[value]
set videofreeze [target]
=on
=off
videofreeze=[target]
Additional VGA source controls
Your VGA source supports all the general source controls described in
previous page, as well as the commands listed in this section. These settings are unavailable when
the projector is in Standby mode or when the VGA sources are disconnected.
N
N O T E
Some of these commands are invalid with HDMI input and composite video sources, and will return
the response “invalidcmd=[command]”.
These commands inform you of the current VGA source settings.
Command
Response
get frequency
frequency=[current frequency setting]
get tracking
tracking=[current tracking setting]
get saturation
saturation=[current saturation setting]
get tint
tint=[current tint setting]
get sharpness
sharpness=[current sharpness setting]
A P P E N D I X
A
Remotely managing your interactive whiteboard system
69
Summary of Contents for Board 600i5
