These commands control the appearance of your VGA source. These settings are unavailable when
the projector is in Standby mode or when the VGA source is disconnected. See
on page 58 for setting absolute and adjustment commands.
Command
Command target range
Response
set frequency [value]
=-5 to =5
frequency=[value]
set tracking [value]
=0 to =63
tracking=[value]
set saturation [value]
=0 to =100
saturation=[value]
set tint [value]
=0 to =100
tint=[value]
set sharpness [value]
=0 to =31
sharpness=[value]
Additional composite video source controls
Your composite video source supports all the general source controls described on the previous page
as well as the commands listed in this section. These settings are unavailable when the projector is in
Standby mode or when the composite video source is disconnected.
N
N O T E
Some of these commands are invalid with VGA video sources.
These commands inform you of the current composite video source settings.
Command
Response
get saturation
saturation=[current saturation setting]
get tint
tint=[current tint setting]
get sharpness
sharpness=[current sharpness setting]
These commands control the appearance of your composite video source. See
on page 58 for setting absolute and adjustment commands.
Command
Command target range
Response
set saturation [value]
=0 to =100
saturation=[value]
set tint [value]
=0 to =100
tint=[value]
set sharpness [value]
=0 to =31
sharpness=[value]
Audio output controls
These commands control your projector’s audio output to your audio system (not included). Audio
output controls aren’t defined by the video source. These settings are unavailable when the projector
is in Standby mode.
A P P E N D I X
A
Remotely managing your interactive whiteboard system
63
Summary of Contents for Board 600iv
