40
Using and Maintaining the Interactive Whiteboard
1. Press the
Menu
button on the projector remote control.
2. Select
Advanced Menu > Projector Options > Menu > Setup
.
3. Click the
Page 4
tab, and then click the
Clear Filter Usage Meter
button.
Replacing the Projector Lamp and Filter in a 2865 or a 2965
Replace the lamp when you see this message: “The lamp has reached the end of its usable life.
Please replace the lamp.” This message appears after you use the projector for 2,000 hours with a
standard lamp in Normal mode. After 2,100 hours in Normal mode, the projector automatically
goes into Standby mode, and it will stay in Standby mode until you replace the lamp. If you’re using
a standard lamp in Eco mode, your lamp should last 3,000 hours before you see the message.
With an extended life lamp, the message appears after 4,000 hours. (This extended-life lamp is
sometimes referred to as Super-Eco mode.)
NOTE:
To find out how many hours of use your projector lamp has left, access the projector menu
and select
Help > Information > Page 4
tab. When you replace the lamp, the lamp usage meter is
automatically cleared, and the projector begins counting the usage hours for the new lamp.
1. Order a replacement standard lamp (NEC MT60LP) or extended life lamp (NEC MT60LPS)
from your NEC or SMART dealer. Don’t use any other lamp.
2. Access the projector through the side of the mirror stand.
3. Replace the lamp according to the instructions on page E-53 of the
NEC MT1065 User’s
Manual
.
4. Replace the projector filter. You’ll receive this filter with your replacement lamp.
To clear the “Please Clean Filter” message
To replace the lamp and filter
WARNINGS
Never touch the back of the screen or brush your head against it while you
examine the internal components
. If you do smudge this surface, lightly spray
alcohol-free glass cleaner onto a soft cloth and gently dab the affected area to
remove the marks. Never apply isopropyl alcohol, water or acetone, as these
fluids will damage the diffusion coating, and permanently reduce the display
quality.
To avoid an electric shock, don’t remove any screws except the two lamp case
screws.
Only replace the projector lamp with the NEC MT60LP standard lamp or the
NEC MT60LPS extended life lamp. These lamps are available from NEC or
SMART. Don’t use any other lamps.
After you turn off the projector, allow at least one minute to elapse before you
unplug it.
Don’t
touch or replace the projector lamp (which will be very hot) for
at least an hour.
Summary of Contents for In-WallRear Projection Interactive Whiteboard
