A P P E N D I X B
Remotely managing your system through an RS-232 serial interface
65
Advanced display controls
These commands control the integration properties of the projector.
Usable command
by power state
Property
Valid values
Notes
Standby
/ idle
On
set or get
projectionmode
• front
• ceiling (default)
• rear
• rear ceiling
set or get
displaymode
• SMARTPresentation
(default)
• Brightroom
• Darkroom
• sRGB
• User
set or get
highbrightness
• on (default)
• off
get
nativeaspectratio
• 16:9
• 16:10
• UX80 reports 16:10
• UX80HD reports 16:9
set or get
aspectratio
• fill (default)
• match
• 16:9
set or get
brightness
Numeric value. Range:
0~100
Default=50
set or get
contrast
Numeric value. Range:
0~100
Default=50
set or get
frequency
Numeric value. Range:
-5~5
Automatically detected from
current video source.
set or get
tracking
Numeric value. Range:
0~31
Automatically detected from
current video source.
set or get
hposition
Numeric value. Range:
0~100
Automatically detected from
current video source.
set or get
vposition
Numeric value. Range:
-5~5
Automatically detected from
current video source.
set or get
whitepeaking
Numeric value. Range:
0~10
Default=10