APPENDIX C
ADJUSTING PROJECTOR SETTINGS
72
smarttech.com/kb/170340
Setting
Use
Notes
Native DLP
Resolution
Selects 16:10 or 16:9.
The default is 16:10, which is the correct
setting for SMART Board 885 interactive
whiteboards.
This option is only available on
SMART UF75w projectors with DDP fimrware
version 0.0.2.1 or later.
When you select 16:10, the projector’s native
resolution is 1280 × 800.
When you select 16:9, the projector’s native
resolution is 1280 × 720.
Network menu
Network
Activates the projector’s RJ45
connector and network
features.
Status
Displays the current network
status (Connected,
Disconnected or Off).
The default is off.
DHCP
Displays the status of the
network’s Dynamic Host
Configuration Protocol (DHCP)
as On or Off.
The default is on.
On enables a DHCP server on the network to
automatically assign an IP address to the
projector.
Off enables an administrator to assign an IP
address manually.
Password
Reminder
E-mails the network password
to the predefined e-mail
recipient.
See
on page 41 to set
up a destination e-mail address.
IP Address
Displays the projector’s current
IP address in values between
0.0.0.0 and 255.255.255.255.
To change the projector’s IP address, use the
RS-232 connector or use a DHCP server to
assign a dynamic IP address, and then set a
static IP address using the network remote
management feature (see
your system through a network interface
Subnet Mask
Displays the projector’s subnet
mask number in values
between 0.0.0.0 and
255.255.255.255.
