34
Maintaining Your 600i2 Interactive Whiteboard System
99-00850-21 B0
To remove the projector plate assembly from the boom
1.
Before you remove the Unifi 45 projector, turn off the
power button switch on the projector, not the ECP, and
allow bulb to cool.
2.
Disconnect the power cord and all connected cables.
3.
Wait at least 15 minutes for the projector to
completely cool.
4.
Close the projector lens door to prevent scratching or
touching of the lens.
5.
While firmly holding the projector with your hand, and
without putting pressure or weight on the projector boom,
unscrew the thumbscrew that connects the projector plate
assembly to the boom.
6.
When this thumbscrew is removed, the projector plate
assembly swings freely. Put the thumbscrew in a safe
place. Carefully disengage the projector plate assembly’s
hinge channel from the connecting flange hook on the
projector boom. Lay the projector flat on your work area.
7.
Unscrew the three screws connecting the projector plate to
the projector. Put the screws in a safe place.
8.
Turn the projector over and lay it on your work area so that
the warning lights and setting buttons face upwards.
WARNING
• If the lamp has shattered or burst, call a
SMART authorized service representative
for
instructions. Do not attempt to replace the lamp.
• Turn the projector off and wait 15 minutes for the lamp to cool completely before removing
the old lamp assembly.
• Wear protective eyewear while changing the lamp. Failure to do so can cause injury or loss
of eyesight if the lamp shatters or bursts.
• Use only the SB20 replacement lamp (SMART Part No. 01-00247).
• The lamp used in the Unifi 45 projector contains mercury. Recycle or dispose of it as
hazardous waste, in accordance with local regulations.
• To prevent premature lamp failure or exposure to mercury, always handle the fragile lamp
assembly with care. Use gloves when touching the lamp. Do not touch the lamp with your
fingers.
• Never replace the lamp assembly with a previously used lamp assembly.
/
2.5 mm
The projector plate assembly includes the
projector plate and the Unifi 45 projector.
Summary of Contents for SmartBoard 600i2
