2. Check the display mode of your computer’s graphics card. Make sure it matches one of the
projector’s compatible signal formats (see
on page 27). Refer to your
computer’s manual for more information.
3. Configure the display mode of your computer’s graphics card to make it compatible with the
projector. Refer to your computer’s manual for more information.
4. Optionally, reset the projector as described in
on page 52 to adjust your
frequency to its original value.
I
I M P O R T A N T
This action resets all values to their defaults.
Unaligned projected image
The SMART UX60 projector image can slip if it’s moved often or installed in a location prone to
vibration, such as next to a heavy door. Follow these precautions to help prevent the image from
becoming misaligned:
l
Make sure that the installation wall is plumb and square and doesn’t move or vibrate
excessively.
l
Make sure that there are no obstructions behind the projector’s wall mount bracket, and that the
bracket is firmly secured to the wall according to the installation instructions.
l
Confirm that all cables are held in place with the appropriate cable clip.
l
Adjust the projected image. See the included
SMART Board X885ix Interactive Whiteboard
System Installation Guide
) and
C H A P T E R 6
Troubleshooting your interactive whiteboard system
50
Summary of Contents for X800ix
