The following table describes the powerstate commands:
Command
Description
on
Turns on the projector.
off
Starts the shutdown process. A dialog box appears with the
message, “Press Power Button to Turn off Projector.” You must send
a second
Off
command within 10 seconds to completely turn off the
projector.
off now
Shuts down the projector immediately. You can’t delay or cancel this
command.
get powerstate
Indicates the projector’s current powerstate.
The following table describes the powerstate fields:
Field
Description
Powering
The projector is turning on.
On
The projector is on.
Cooling
The projector is cooling.
Confirm off
Confirm off
is a non-selectable powerstate that is returned during
stage one of the two-button
off
sequence.
Idle
The projector is off but still receiving power (Standby mode).
Source selection controls
These commands switch input sources. The source type determines which commands can be
accepted.
Command
Response
Available when powered
off
get input
input=[field]
Yes
set input [field]
input=[field]
No
The following table describes the source selection commands:
Command
Description
get input
Returns the projector’s current input.
set input [field]
Returns the input to one of the selectable fields.
A P P E N D I X
A
Remotely managing your interactive whiteboard system
66
Summary of Contents for X800ix
