These commands inform you of the current audio output settings.
Command
Response
get volume
volume=[current volume setting]
get mute
mute=[current mute setting]
get volumecontrol
volumecontrol=[current volume control setting]
get cc
cc=[current closed captioning language setting]
These commands control your audio output settings. See
73 for setting absolute and adjustment commands.
Command
Command target range
Response
set volume [value]
=-20 to =20
volume=[value]
set mute [target]
=on
=off
mute=[target]
set volumecontrol [target]
=on
=off
volumecontrol=[target]
set cc [target]
=cc1
=cc2
=off
cc=[target]
N
N O T E
Typically, cc1 displays American English subtitles, while cc2 displays other regional languages,
such as French or Spanish, depending on television channel or media setup.
Network controls
These commands control your projector’s network status and settings. These settings are available
even when the projector is off.
These commands inform you of the current network settings.
Command
Response
get netstatus
netstatus=connected
netstatus=disconnected
netstatus=disabled
get dhcp
dhcp=[current DHCP status]
get ipaddr
ipaddr=[current IP address]
get subnetmask
subnetmask=[current subnet work mask number]
get gateway
gateway=[current network gateway]
get primarydns
primarydns=[current primary domain name number]
get macaddr
macaddr=[current MAC address]
A P P E N D I X
A
Remotely managing your interactive whiteboard system
78
Summary of Contents for X880i4
