Page
5
Page
6
HALOGEN LAMP INSTALLATION
WARNING
:
RISK OF SEVERE BURNS. LAMP HEAD AND BULB
ARE EXTREMELY HOT DURING AND IMMEDIATELY AFTER USE.
Touching lamp heads or bulbs with bare hands while work light is on
can cause severe burns. Turn off and unplug work light and allow it to
cool completely before attempting to change bulbs.
CAUTION
: RISK OF DAMAGING BULB! NEVER TOUCH BULB
SURFACE WITH YOUR BARE HANDS!
The natural oil from your skin can leave a residue that could cause the
bulb to fail prematurely. If you accidentally touch the bulb with your
bare hands, wipe the bulb thoroughly with alcohol and soft cloth
or tissue before installing. ALWAYS USE A CLEAN CLOTH OR TISSUE
WHEN HANDLING THE BULB.
WARNING
: RISK OF FIRE AND PERSONAL INJURY.
The lamp head on this work light is designed to operate safely with
two
300
-watt bulb. To avoid damage to the work light, DO NOT USE A
BULB OVER
300
-watts IN THIS WORK LIGHT.
Install halogen bulb into lamp head
The halogen bulb (F) is shipped in a protective box inside the lamp
head.
1)
Remove the center screw at the top of the lamp head (A) and lower
the hinged frame with glass lens.
Fig. 5
and
Fig 6.
2)
Remove bulb (F) from its box and wrapper, being careful not to
touch the bulb with your bare hands. Only use a clean cloth or tissue
to handle the bulb
3)
4)
Insert the other ceramic end of the bulb into the other lamp holder
socket. Make sure that the bulb (F) makes secure contact at both lamp
holder sockets. When properly installed, the bulb can be rotated about
45° (1/8 of a turn) on its axis with very little or no resistance. Replace
the hinged front frame with glass lens. Then replace and tighten the
center screw. Repeat above steps for other lampholder.
HALOGEN LAMP REPLACEMENT
WARNING
:
Risk of severe burns. Bulb housing and bulbs are
extremely hot during and immediately following use. Touching
housing or bulb with bare hands while unit is lit can cause se-
vere burns. Unplug light and allow it to cool completely before
attempting to change lamp.
To remove lamp:
1. Unplug and allow the light housing (A) and bulb (F) to cool.
2. Remove the center screw at the top of the light head (A) and lower
the hinged lens cover.
3. Using a cloth to safely grasp the burned out lamp (F), gently push
the lamp to the right. You will feel the lamp holder spring retract, free-
ing the other end of the lamp.
4. Lift and remove the bulb (F).
To replace lamp:
To install a new lamp, follow all instructions in the HALOGEN LAMP IN-
STALLATION section of this manual.
SAVE THESE INSTRUCTIONS!
SAVE THESE INSTRUCTIONS!
Fig. 5
Fig. 6
Fig. 7
Hold the bulb (F) at its center with a clean cloth or tissue and
gently push one ceramic end of the bulb (F) into the bulb holder
to engage right side first. See
Fig.7
