-5-
Installation
Remember
there are specific standards that have to
be strictly followed regarding the safety of electrical
installations and automatic gates and doors.
As well as the legal requirements and standards that
must be adhered to, please take note of the following
points to ensure maximum safety and reliability of your
installation.
1.1) Prior to installing check the surrounding
environment. Carefully evaluate any hazards there
could be from physical damage (transiting vehicles,
parts of trees falling etc.), possible contact with
foreign bodies (insects, leaves, etc.), Flooding
hazards or any others exceptional events.
1.2) Check that the main voltage is the same as that
given on the rating plate and in this manual.
1.3) Check there is suitable electrical protection against
short circuits/power spikes and proper earthing on
the main supply.
Remember
the unit has mains voltage running through it
(electrocution hazard, fire hazard).
1.4) Take care with the control unit; parts may be
subject to damage if abused.
1.5) Make sure you have all the necessary materials
and that they are suitable for this kind of use.
1.6) Read all the instructions thoroughly and make sure
they are understood before attempting to install the
Smart Lifter.
1.7) Before starting the installation, carefully analyse all
the risks relating to automating the door. Verify that
the door to be automated is in a sound condition
and that the mechanisms are in good working
order; observe the safety margins and minimum
distances.
1.8) Evaluate with particular care the safety devices to
be installed and where to install them; always install
an emergency stop device for interruption of power
to the opener if required.
1.9) Once the risks have been analysed, install the
Smart Lifter opener and relative safety devices,
emergency stop and/or photoelectric cells.
Important:
For additional safety Smart Openers Pty Ltd
strongly recommends the fitting of Photo Electric safety
beams on all installations.
1.10) When installing the Smart Lifter opener, strictly
follow all the instructions given in the instruction
manual. If some points or procedures in this manual
are not very clear do not install the unit until all
doubts have been cleared up with our technical
department.
Refer to above for recommended installation
1) Smart Lifter sectional door opener
2) 24V DC flashing light (optional extra)
3) Key selector switch or digital keypad
4) Photo beam (RX/TX Type)
5) Inside push button panel
6) Power point
7) Power head
Fig. 1
1
2
3
4
4
5
6
7
