Smart Openers Smart Roller Shutter, Installation Manual

Remote 001

Del Remote
All

-14-

Coding Transmitters

Note:

  There is no need to store buttons individually into 

memory. By coding a transmitter into the openers 

memory it automatically defaults to Button 1 for full 

access and Button 2 for pedestrian mode.

1.

   Press 

CODE

, the LCD displays 

Code Learn

. 

Press any button on the transmitter, the LCD will 

display 

Remote 001

. 

2.

   Press the same button again, the display will show 

Code Set

.

Note:  

Code Learn

 will display for 5 secs after last 

the last TX is coded to store additional TXs. If 

maximum code storage capacity is reached (200 

transmitters) the display will show 

Code Full

.

Remote TX Coding (Hands Free Learning) 

It is possible to code a new transmitter via an already coded 

remote without being in contact with the control panel. 

1. 

Ensure Hands Free Learning is enabled (page 13).

2.   

Press TX Buttons 3 + 4 together for 2 secs. The 

opener will beep to signal Code Learn Mode.

3.   

Press any button on new transmitter twice (Fig. 11). 

The opener will beep to confirm code learned.

Deleting One Transmitter

1.

   Press and hold 

CODE

 for 5 seconds. The LCD will 

display 

Del Remote All

. 

2.

   Press 

SET

 to scroll up or PB to scroll down to the 

desired transmitter number - 

Remote 023

. 

3.

   Press and hold 

CODE

 for 3 secs to confirm. The 

stored code has now been deleted.

Replacing One Transmitter

1.

   Press 

CODE

. The LCD will display 

Code Learn

.

2.

   Press transmitter button once, the LCD will display 

the previously deleted number e.g. 

Remote 023

. 

Press Button again to confirm.

Deleting All Transmitters

1.

   Press and hold 

CODE

 for 5 seconds. The LCD will 

display 

Del Remote All

. 

2.

   Press and hold 

CODE

 for 3 secs to confirm. All stored 

codes have now been deleted.

Transmitter Button Allocation

Note:  

The Smart Roller Shutter is factory preset with TX 

Button 1 operating full access (PB) and Button 2 

for Pedestrian Mode (PD). The following procedure 

alters these settings for all coded transmitters.

1.

   Press 

MENU

 for 3 secs. Press 

SET

 to cycle through 

to Transmitter Allocation menu (Fig. 28). The LCD will 

display functions on the first line and button allocation 

on the second.

2.

   Press 

PB

 to cycle through buttons 1–4 (0 to disable).

Note:

  To allocate all buttons to a function press and hold 

PB

 until the display shows 

All

.

3.

   Press 

MENU

 to allocate the button and move to the 

next function and repeat as required.

4.

  Press 

MODE

 to save and exit to normal operation.

Note:  

If a button is already allocated to one function it will 

not be available for any other.

PB PD OP CL
01 02 00 00

Fig. 26

Existing 

Remote

Uncoded 

Remote

Code Learn

Fig. 24

Fig. 25

Fig. 27

Fig. 28

© June 2009 Smart Openers Pty Ltd